So I have my AC connected to a smart plug and I’m trying to figure out what would be the best way to go about automating it.
Currently, I have it set to run every hour on the hour for 20 minutes if the time is between noon and 8 p.m. Which covers the hottest part of the day.
However, what I could do is have it run every other hour instead and have a couple of night runs along with the daytime runs.
Doing it that way would eliminate most of the 16-hour period currently that exists between the ending of one day and the beginning of the next.
Edit: Also, is there an easy way to automate every other hour using the time pattern or would I manually have to set up triggers for 2am, 4am, 6am, 8am, 10am, etc. using the fixed values?
Edit 2: looks like i can use “/2” to accomplish that
Monitor the current with the smart plug. When you want to turn it off, wait for the current to drop for a few minutes (this means the compressor is off/unloaded) then power off the outlet.
Might be an idea.
I can’t do that. Without doing it myself, the compressor will absolutely never turn off. Unless I manually flip the switch. There was another commenter below that said that it wasn’t a problem as long as you didn’t try to start it up again too quickly and I don’t so that’s all right
I’ve never seen a window AC with mechanical knobs not cycle the compressor when it hits the temperature set by its thermostat. The fan might run 24/7 but the compressor? How could it possibly regulate temperature otherwise?
Oh duh, I totally forgot about that. There is a knob to regulate the temperature, and that will kick the compressor off. Currently I just have it set to as cold as it will get and then cut power to the unit itself with the plug. It stays off for a good 40 minutes at a time, which is plenty of time to drain the pressure properly before starting up again.