I needed another corded mouse and this time around I thought of @[email protected] and @[email protected] instead of Logitech’s shareholders. These guys make open source mice among other open source hardware under the brand Ploopy. You can order one from them, assembled or as a kit, or you could print and build it entirely by yourself.
The mouse itself is pretty great. Coming from a long line of Logitech (MX518/G5/G500/G502), it’s a bit larger than what I’m used to but I think I’m getting accustomed to it.
Here’s another shot of it:
Isn’t there severe issues with micro plastics doing this? Serious question. I’ve just heard in general on 3d prints that they’re more prone to shedding.
If you do the smoothing steps it can be OK, especially if you sand it in a sealed environment or with a HEPA vacuum handy to suck up all of the particulates. Once it is sanded you can do a short acetone treatment and the surface will be melted smooth. It can take some practice, but you can seal it up pretty well without sacrificing quality. Just be mindful of air quality and filtering at each step so you don’t undermine your goal.
Also, no matter what the microplastic impact on the environment is less than a mouse made in a factory thar doesn’t pay attention to any of its air quality standards.
Gotcha. Thanks for the type up!
I would literally eat a spoon of microplastics if it meant I got a mouse that was comparable to my G602. Not saying this mouse does that but there certainly aren’t any commercial options I could find.
need to take it real old, print it in abs and do a vapor smoothing in acetone.
You could also print this in a goo printer and not have the issue.
Interesting. I always wondered if the same rule applied to the ‘goo’ type as my friend has one.
They definitely don’t shed much when they’re new. They’re quite playable and don’t sand easily
Now you leave it in the sun for a year, they do get brittle, I suspect at that point you might be able to sand them on a table surface.