• Showroom7561@lemmy.ca
    link
    fedilink
    English
    arrow-up
    1
    ·
    19 hours ago

    And my feeling is that they aren’t using the gains from this to make the batteries last, as SUPERVOOC is faster than pretty much every other standard. That makes me think they turned in any and all gains in battery health, for speed.

    There is a setting to explicitly benefit from using an official charger and cable, but I don’t know if it’s on by default (it’s disabled on my phone).

    That said, the heat while charging is about the same as the heat from holding the phone in my hand (around 38C), and doesn’t get much hotter than that while gaming thanks to pass-through charging.

    My Samsung was definitely hotter, and would overheat if charging while doing anything like GPS navigation. But my last Samsung was a Note 10+, and so things may have very well changed since then.

    You may want to use something like AccuBattery

    Already do, and have for years.

    But AccuBattery doesn’t seem to play nice with the OP13, with many users reporting lower battery health from the start (80-90%), and inaccurate capacity (<1000 mAh less than the designed capacity).

    Coupled with the fact that it’s only accurate if you are constantly charging from below 15% to 100%, these are ranges that I rarely get my phone into.

    Even though battery longevity is important to me, since I no longer replace my phones “every year”, it really would be best if these damn things had user-replaceable batteries that were readily available. 😫

    • amorpheus@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      14 hours ago

      around 38C

      I was shocked when my new realme, which uses the same tech, didn’t even break 30°C while charging at 8+ Amps (should be around 80W). This was in a relatively warm room (25°C) and using the case that came with it, which surely doesn’t improve thermals. It gets warmer when charging from other sources with only 2-3A, like USB-PD or QuickCharge.

      Coupled with the fact that it’s only accurate if you are constantly charging from below 15% to 100%, these are ranges that I rarely get my phone into.

      AccuBattery needs a session to have 60% charged, so <20% to 80% works. Doesn’t need to be every single one. I actually asked support about it and they said this was the lowest percentage they were comfortable with. I was requesting to make it adjustable.

      Accuracy of the measurement isn’t the entire point. I see the same issue, but since it helps track relative degradation over time it can still add value by giving more information when you suspect the capacity is getting worse.

      • Showroom7561@lemmy.ca
        link
        fedilink
        English
        arrow-up
        1
        ·
        12 hours ago

        I was shocked when my new realme, which uses the same tech, didn’t even break 30°C while charging at 8+ Amps (should be around 80W). This was in a relatively warm room (25°C) and using the case that came with it

        That’s impressive. I’m looking at my phone now, not charging, but the screen is on, and it’s at 33C. LOL

        AccuBattery needs a session to have 60% charged, so <20% to 80% works. Doesn’t need to be every single one.

        It’s rare for me to get that low, even while charging to 80%. 😵

        But yeah, every so often I’ll let it drain, then do a 100% charge to see what’s up. I don’t like doing that, because even Accubattery says that takes up more of a charge cycle than charging conservatively.

        I do like the trend chart, although, the battery health on that actually went UP 5% between March and May 😱